The pulley is an important component of belt conveyor, which can drive, change direction or take up belt conveyor at conveyor tail or other locations.

TechSolutions is capable of design, fabrication, install & commission various different types of pulleys according to client’s technical requirements. TechSolutions pulley adopts unique structure, reasonable coordination and precise assembly, which can guarantee the maximum load-bearing capacity and the longest service life. Under the same workload and working environment, all performance data of our pulleys are ahead of similar products.

Pulley is usually assembled with pulley shell, disc, shaft, bearing, bearing housing, locking system, labyrinth seal and snap ring, etc.

Key Features:

• Long service life
• Small radial runout
• Low rotation resistance

TechSolutions pulley for belt conveyor can be customized by clients, the pulley diameter can be from 250mm to 1800mm, the pulley can be applied for the belt conveyors with belt width ranging from 500mm to 2400mm.

Pulley can be classified into several types as per its functions as follows:

• Drive pulley: used at conveyor tail or other locations to drive the conveyor moving smoothly.
• Bend pulley: used at conveyor tail, take-up or elevator boot locations where material tends to build up on the pulley face.

TechSolutions pulley for belt conveyor can be customized by clients, the pulley diameter can be from 250 mm to 1800 mm, and the pulley can be applied for the belt conveyors with belt width ranging from 500mm to 2400mm.

up to 1800 mm

600 – 2400 mm

up to 20,500 t/h (or 17100m³/h)

ANSI, CEMA, AS, GB, ISO, etc.

Note: Above data can be adapted and may vary according to client’s requirement.